1. Take
any container or bottle of any size of glass, plastic, crystal or any
other material except for metal.
2. Fill the container with water up to 75% of its capacity leaving the top 25% empty. In case the water container is full, then empty out only the top 25% of the container.
Note: The water that can be used for the Vibrational Water can be any type of water you drink at home. Distilled, Filtered, Spring, Tap, Alkaline, Reverse Osmosis, Boiled, Purified, water with electrolytes, and any other form of potable water is good to create Vibrational Water.
3. Pour
two (2) drops from the vial of alcohol containing the Quantum Healing Vibrations per liter (34 Fluid Oz) of water into
the container.
For a gallon you can pour 8 drops.
- 4. Close the container with its cap and shake it immediately to spread the Vibrational Frequencies throughout the container of water.
- The process of shaking it is a fast yet soft movement of the wrist up and down about 50-100 times.
Drink the Vibrational
Water any way you want and you can drink as much of this water as you desire.
There is no limit to the amount of Vibrational Water that can be consumed.
5. One (1) sip of Vibrational Water is
considered to be a dose. Ideally each sip of Vibrational Water should consist
of a sip of reasonable size that goes sublingual (underneath the tongue) for
2-10 seconds and then swallowed.
There is no such thing as an excessive dose or
overdose with Vibrational Water. In fact, the more Vibrational
Water a person drinks with a higher consistency throughout the day, the faster
and more efficient the results will be!
It can
be consumed cold or at room temperature.
The secret to faster results with Vibrational Water is to drink as many small sips of Vibrational Water throughout the day every 2-15 minutes with the highest repetitive frequency possible per bottle.
The very minimum dosage required throughout a day is 3 sips of water per day per bottle.
The
Vibrational Water is easily reproduced and it is recommended to do so several
times a day for about 5-7 days before adding a new drop from the vial of Vibrational Frequencies in alcohol.
To
reproduce the Vibrational Water you only need about the last 25% of the
Vibrational Water left
in the container.
To
the last remaining 25% of the
Vibrational Water in the container , add water up to about 75% of the content of the container filled, leaving the top 25% of the container empty and shake
immediately about 50-100 times.
You
see, the remaining 25% of the Vibrational Water contains the Vibrational Frequencies that you want to
reproduce. Fortunately, these Vibrational
Frequencies are DOMINANT over
every other type of frequencies of vibrations; therefore, they will
reconfigurate the new added water to its own Vibrational Frequency.
You can reproduce the Vibrational Water several times a day and continue to do so for up to about 5-7 days before starting a new bottle with a new drop from the vial of alcohol containing the Vibrational Frequencies. That means that you will be reproducing the water over and over for up to a week, and will use the alcohol drops only once every 5-7 days or less, but not daily.
If you drink the Vibrational Water directly out of the container it is recommendable to reproduce the Vibrational Water for no more than 3-4 consecutive days. This means that if you are drinking the Vibrational Water directly from the container it is highly recommendable to start a new bottle with a new alcohol drop every 3-4 days instead of every week. The reason for this is because the direct contact of the mouth with the container may affect the purity of the water. It will not affect the Vibrations per se, but after a few days the taste and smell of the water may change due to its direct contact with saliva particles.
When
cleaning the container DO NOT use any kind of soap. Rinse clean only with tap
water.
Keep
the container of Vibrational Water and the vials of alcohol away from having
direct contact with sunrays, metallic containers, and MICROWAVE OVENS.